Transcription
CD RDS RECEIVERDEH-150MPDEH-15MPOwner’s Manual
Section01Before you startThank you for purchasing this PIONEERproductTo ensure proper use, please read through thismanual before using this product. It is especiallyimportant that you read and observe WARNINGs and CAUTIONs in this manual. Pleasekeep the manual in a safe and accessible place forfuture reference.This device complies with Part 15 of the FCCRules. Operation is subject to the followingtwo conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interferencethat may cause undesired operation.Information to UserAlteration or modifications carried out without appropriate authorization may invalidatethe user’s right to operate the equipment.Before you startNoteThis equipment has been tested and foundto comply with the limits for a Class B digitaldevice, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interferencein a residential installation. This equipmentgenerates, uses and can radiate radio frequency energy and, if not installed and usedin accordance with the instructions, maycause harmful interference to radio communications. However, there is no guaranteethat interference will not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be determined by turningthe equipment off and on, the user is encouraged to try to correct the interference by oneor more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on acircuit different from that to which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.The Safety of Your Ears is inYour HandsGet the most out of your equipment by playing itat a safe level—a level that lets the sound comethrough clearly without annoying blaring or distortion and, most importantly, without affectingyour sensitive hearing. Sound can be deceiving.Over time, your hearing “comfort level” adapts tohigher volumes of sound, so what sounds “normal” can actually be loud and harmful to yourhearing. Guard against this by setting yourequipment at a safe level BEFORE your hearingadapts.ESTABLISH A SAFE LEVEL:! Set your volume control at a low setting.! Slowly increase the sound until you can hearit comfortably and clearly, without distortion.! Once you have established a comfortablesound level, set the dial and leave it there.BE SURE TO OBSERVE THEFOLLOWING GUIDELINES:! Do not turn up the volume so high that youcan’t hear what’s around you.! Use caution or temporarily discontinue usein potentially hazardous situations.! Do not use headphones while operating amotorized vehicle; the use of headphonesmay create a traffic hazard and is illegal inmany areas.About this unitThe tuner frequencies on this unit are allocatedfor use in North America. Use in other areasmay result in poor reception.WARNINGHandling the cord on this product or cords associated with accessories sold with the productmay expose you to chemicals listed on proposition 65 known to the State of California andother governmental entities to cause cancer andbirth defect or other reproductive harm. Washhands after handling.CAUTION:USE OF CONTROL OR ADJUSTMENT ORPERFORMANCE OF PROCEDURESOTHER THAN THOSE SPECIFIED HEREINMAY RESULT IN HAZARDOUS RADIATIONEXPOSURE.CAUTION:THE USE OF OPTICAL INSTRUMENTSWITH THIS PRODUCT WILL INCREASEEYE HAZARD.CAUTION! Do not allow this unit to come into contactwith liquids. Electrical shock could result.Also, damage to this unit, smoke, and overheating could result from contact withliquids.! Always keep the volume low enough to hearoutside sounds.! Avoid exposure to moisture.! If the battery is disconnected or discharged,any preset memory will be erased.Important (Serial number)The serial number is located on the bottom ofthis unit. For your own security and convenience, be sure to record this number on the enclosed warranty card.NoteFunction setting operations are completed evenif the menu is canceled before the operationsare confirmed.
SectionBefore you startOperating this unit0102After-sales service forPioneer productsPlease contact the dealer or distributor fromwhere you purchased this unit for after-salesservice (including warranty conditions) or anyother information. In case the necessary information is not available, please contact the companies listed below:Please do not ship your unit to the companies atthe addresses listed below for repair without advance contact.http://www.pioneerelectronics.ca! Learn about product updates (such as firmware updates) for your product.! Register your product to receive noticesabout product updates and to safeguard purchase details in our files in the event of lossor theft.! Access owner’s manuals, spare parts information, service information, and muchmore.Head unitRemote controller buttons marked with thesame numbers as on the unit operate in thesame way as the corresponding unit button regardless of button name.1 2 34 5 6e7 89 abPartc dh ONTROL(M.C.)ac/db1/4567(list)DISPDisc loading slot(equalizer)a8lk2jPart1In case of troubleShould this unit fail to operate properly, pleasecontact your dealer or nearest authorizedPIONEER Service Station.Remote controlcdiPartOperationeVOLUMEPress to increase or decreasevolume.fMUTEPress to mute. Press again tounmute.ga/bPress to recall preset stations.Press to select the next/previous folder.hAUDIOPress to select an audio function.iDISP/SCRLPress to select different displays.Press and hold to turn dimmeron or off.jePress to pause or resume playback.to 6/AUX input jack(3.5 mm stereojack)fghDetach button
SectionOperating this unit02PartklOperating this unitIndicatorOperationFUNCTIONPress to select functions.LIST/ENTERPress to display the disc title,track title, folder, or file list depending on the source.Press to display the list depending on the source.While in the operating menu,press to control functions.78Main information sectionState! Tuner: band and frequency! CD player: elapsed playback time and text informationAppears when a lower tier offolder or menu exists.Set up menuDisplay indication1234 65When you turn the ignition switch to ON after installation, set up menu appears on the display.You can set up the menu options below.1 After installation of this unit, turn theignition switch to ON.SET UP appears.782Indicator12(list)Sub information section3(sound retriever)4LOC56(repeat)(random)StateThe list function is being operated.Turn M.C. to switch to YES.# If you do not operate for 30 seconds, the set upmenu will not be displayed.# If you prefer not to set up at this time, turn M.C.to switch to NO. Press to select.If you select NO, you cannot set up in the set upmenu.Sub information is displayed.3The sound retriever functionis on.Local seek tuning is on.Press M.C. to select.4 Complete the procedure outlined belowto set the menu.To proceed to the next menu option, you need toconfirm your selection.Track or folder repeat is on.CLOCK SET (setting the clock)Random play is on.1234Turn M.C. to adjust hour.Press M.C. to select minute.Turn M.C. to adjust minute.Press M.C. to confirm the selection.QUIT appears.5 To finish your settings, turn M.C. to selectYES.# If you prefer to change your setting again, turnM.C. to switch to NO. Press to select.6Press M.C. to select.Removing the front panel to protect your unit fromtheft1 Press the detach button to release the frontpanel.2 Push the front panel upward (M) and then pullit toward (N) you.Notes! You can set up the menu options from thesystem menu. For details about the settings,refer to System menu on page 7.! You can cancel set up menu by pressingSRC/OFF.Basic operations!!!!ImportantHandle gently when removing or attachingthe front panel.Avoid subjecting the front panel to excessiveshock.Keep the front panel out of direct sunlightand high temperatures.To avoid damaging the device or vehicle interior, remove any cables and devices attachedto the front panel before detaching it.3 Always keep the detached front panel in a protection device such as a protection case.Re-attaching the front panel1 Slide the front panel to the left.Make sure to insert the tabs on the left side ofthe head unit into the slots on the front panel.2 Press the right side of the front panel until it isfirmly seated.If you cannot attach the front panel to thehead unit successfully, make sure that you areplacing the front panel onto the head unit correctly. Forcing the front panel into place mayresult in damage to the front panel or headunit.Turning the unit on1 Press SRC/OFF to turn the unit on.Turning the unit off1 Press and hold SRC/OFF until the unit turnsoff.
SectionOperating this unitSelecting a source1 Press SRC/OFF to cycle between:TUNER (tuner)—CD (CD player)—AUX (AUX)Adjusting the volume1 Turn M.C. to adjust the volume.Operating this unitWARNING! Keep the battery out of the reach of children.Should the battery be swallowed, consult adoctor immediately.! Batteries (battery pack or batteries installed)must not be exposed to excessive heat suchas sunshine, fire or the like.CAUTIONFor safety reasons, park your vehicle when removing the front panel.NoteWhen this unit’s blue/white lead is connected tothe vehicle’s auto-antenna relay control terminal, the vehicle’s antenna extends when thisunit’s source is turned on. To retract the antenna, turn the source off.Use and care of the remotecontrolUsing the remote control1 Point the remote control in the direction of thefront panel to operate.When using for the first time, pull out the filmprotruding from the tray.Replacing the battery1 Slide the tray out on the back of the remotecontrol.2 Insert the battery with the plus ( ) and minus(–) poles aligned properly.CAUTION! Use one CR2025 (3 V) lithium battery.! Remove the battery if the remote control isnot used for a month or longer.! There is a danger of explosion if the battery isincorrectly replaced. Replace only with thesame or equivalent type.! Do not handle the battery with metallic tools.! Do not store the battery with metallic objects.! If the battery leaks, wipe the remote controlcompletely clean and install a new battery.! When disposing of used batteries, complywith governmental regulations or environmental public institutions’ rules that apply inyour country/area.! “Perchlorate Material – special handling mayapply.Important! Do not store the remote control in high temperatures or direct sunlight.! The remote control may not function properlyin direct sunlight.! Do not let the remote control fall onto thefloor, where it may become jammed underthe brake or accelerator pedal.Frequently used menuoperations02Storing and recalling stationsfor each bandUsing preset tuning buttonsReturning to the previous displayReturning to the previous list (the folder one levelhigher)1 Press /DIMMER.1 When you find a station that you wantto store in memory, press one of the presettuning buttons (1/ to 6/ ) and hold untilthe preset number stops flashing.Returning to the ordinary displayCanceling the main menu1 Press BAND.2 Press one of the preset tuning buttons(1/ to 6/ ) to select the desired station.Returning to the ordinary display from the list1 Press BAND.Switching the displayTunerBasic operationsSelecting a band1 Press BAND until the desired band (FM1,FM2, FM3 for FM or AM) is displayed.Switching preset stations1 Press c or d.! Select PCH (preset channel) under SEEK touse this function. For details about the settings, refer to SEEK (left/right key setting) onthe next page.Manual tuning (step by step)1 Press c or d.! Select MAN (manual tuning) under SEEK touse this function. For details about the settings, refer to SEEK (left/right key setting) onthe next page.Seeking1 Press and hold c or d, and then release.You can cancel seek tuning by briefly pressingc or d.While pressing and holding c or d, you canskip stations. Seek tuning starts as soon asyou release c or d.Selecting the desired text information1 Press DISP to cycle between the following:! BRDCST INFO (program service name/song title/artist name)! FREQUENCY (frequency)! CLOCK (source name and clock)Notes! BRDCST INFO text information will changeautomatically.! Depending on the band, text information canbe changed.! Text information items that can be changeddepend on the area.Function settings1Press M.C. to display the main menu.2 Turn M.C. to change the menu optionand press to select FUNCTION.3 Turn M.C. to select the function.Once selected, the following functions can beadjusted.
Section02Operating this unitBSM (best stations memory)BSM (best stations memory) automatically storesthe six strongest stations in the order of their signal strength.1 Press M.C. to turn BSM on.To cancel, press M.C. again.LOCAL (local seek tuning)Local seek tuning lets you tune in to only thoseradio stations with sufficiently strong signals forgood reception.1 Press M.C. to select the desired setting.FM: OFF—LV1—LV2—LV3—LV4AM: OFF—LV1—LV2The highest level setting allows reception ofonly the strongest stations, while lower levelsallow the reception of weaker stations.SEEK (left/right key setting)You can assign a function to the left and right keysof the unit.Select MAN (manual tuning) to tune up or downmanually or select PCH (preset channel) to switchbetween preset channels.1 Press M.C. to select MAN or PCH.CD/CD-R/CD-RWBasic operationsPlaying a CD/CD-R/CD-RW1 Insert the disc into the disc loading slot withthe label side up.Ejecting a CD/CD-R/CD-RW1 Press h.Selecting a folder1 Press 1/ or 2/ .Selecting a track1 Press c or d.Operating this unitFast forwarding or reversing1 Press and hold c or d.! When playing compressed audio, there is nosound during fast forward or reverse.Returning to root folder1 Press and hold BAND.Switchi
theft 1 Press the detach button to release the front panel. 2 Push the front panel upward (M) and then pull it toward (N) you. 3 Always keep the detached front panel in a pro-tection device such as a protection case. Re-attaching the front panel 1 Slide the front panel to the left. Make sure to insert the tabs on the left side of
