WIXLIB

VIPER LOPTICSCat.#TypeJobApprovalsLARGE VIPER LUMINAIREIntended Use:Controls/Options:The Beacon Viper luminaire is available in twosizes with a wide choice of different LED wattageconfigurations and optical distributions designedto replace HID lighting up to 1000W MH or HPS.Luminaires are suitable for wet locations. Available with an optional passive infrared(PIR) motion sensor capable of detectingmotion 360 around the luminaire. Whenno motion is detected for the specified time,the motion response system reduces thewattage to factory preset level, reducing thelight level accordingly. When motion isdetected by the PIR sensor, the luminairereturns to full wattage and full light output.Please contact Beacon Products if projectrequirements vary from standard configuration. Available with Energeni for optional setdimming, timed dimming with simple delay, ortimed dimming based on time of night truction: Manufactured with die cast aluminum. Coated with a polyester finish that meetsASTM B117 corrosion test requirementsand ASTM D522 cracking and loss ofadhesion test requirements. External hardware is corrosion resistant. One piece optical cartridge system consistingof an LED engine, LED lamps, optics, gasketand stainless steel bezel. Cartridge is held together with internal brassstandoffs soldered to the board so that it canbe field replaced as a one piece optical system. Two-piece silicone and microcellularpolyurethane foam gasket ensures aweather-proof seal around each individual optic.Electrical:DIMENSIONSABDInstallation: Mounting options for horizontal arm, verticaltenon or traditional arm mounting available.Mounting hardware included.Finish: IFS polyester powder-coat electrostaticallyapplied and thermocured. IFS finish consists of afive stage pretreatment regimen with a polymerprimer sealer and top coated with a thermosetsuper TGIC polyester powder coat finish. The finish meets the AAMA 2604performance specification which includespassing a 3000 hour salt spray test forcorrosion resistance and resists cracking orloss of adhesion per ASTM D522 and resistssurface impacts of up to 160 inch-pounds.Certifications/Ratings: DesignLights Consortium (DLC) qualified,consult DLC website for more details:http://www.designlights.org/QPL Certified to UL 1598, UL 8750, and CSA C22.2 3G rated for ANSI C136.31 high vibrationapplications with MAF mounting IDA approved This product is approved by the Florida Fishand Wildlife Conservation Commission.Separate spec available at:FrontWeight:DCAB4.13” 25.0 lbs14.25”29.9”24.19”(741 mm) (614 mm) (362 mm) (105 mm) (11.3 kg)EPA1.2 ft2MOUNTING OPTIONSSide ViewBack ViewRectangular Arm (A)Accepts 2 3/8” ODtenon, min 4” long.Side ViewBack View2-3/8” OD Slip Fitter (MAF)27.90”6.63”6.00”2-3/8” Adjustable Knuckle (K)Limit to 30O tilt - Sensor, photocelss and wirelesscontrols should not be tilted above ducts/viper large29.69”Warranty:Five year limited warranty for more information 38”6.00” Luminaire accepts 100V through 277V, 50 Hzto 60 Hz (UNV), 347V, or 480V input. Power factor is .90 at full load. Dimming drivers are standard, but mustcontact factory to request wiring leads forpurpose of external dimming controls. Component-to-component wiring within theluminaire may carry no more than 80% ofrated load and is certified by UL for use at600VAC at 90 C or higher. Plug disconnects are certified by UL for useat 600 VAC, 13A or higher. 13A ratingapplies to primary (AC) side only. Fixture electrical compartment shall contain allLED driver components and shall be providedwith a push-button terminal block for ACpower connections. Optional 7-pin ANSI C136.41-2013 twist-lockphoto control receptacle available. Compatiblewith ANSI C136.41 external wireless controldevices. Ambient operating temperature -40 C to 40 C Surge protection - 20kA. Lifeshield Circuit - protects luminaire fromexcessive temperature. The deviceshall activate at a specific, factory-presettemperature, and progressively reduce powerover a finite temperature range. Operation shallbe smooth and undetectable to the eye.Thermal circuit is designed to “failon”, allowing the luminaire to revert to fullpower in the event of an interruption of itspower supply, or faulty wiring connection tothe drivers. The device shall be able toco-exist with other 0-10V control devices(occupancy sensors, external dimmers, etc.). In addition, Viper can be specifiedwith SiteSync wireless control systemfor reduction in energy and maintenance costswhile optimizing light quality 24/7. For moredetails, see ordering information or visit:www.hubbelllighting.com/sitesyncPRODUCT IMAGE(S)CSPECIFICATIONS5.50”Wall Bracket (WB)32.25”7-75”AD Decorative ArmCERTIFICATIONS/LISTINGS4x 0.50”1”4.88”0.56”*3000K and warmer CCTs onlyBeacon Products 2041 58th Avenue Circle East Bradenton, FL 34203 Phone: 800-345-4928Due to our continued efforts to improve our products, product specifications are subject to change without notice. 2019 BEACON PRODUCTS, All Rights Reserved For more information visit our website: www.beaconproducts.com Printed in USA April 17, 2019 2:40 PM

ORDERING INFORMATIONORDERING EXAMPLE: RIESVPL ViperLED L-395CCT/CRI7ROTATION135W LED array3K7 3000K, 70 CRI180W LED array4K7 4000K, 70 CRILeave blank for norotation235W LED array5K7 5000K, 70 CRI220W LED arrayDISTRIBUTION280W LED array315W LED array395W LED arrayL5 Optic rotation leftR5 Optic rotation rightFR2344W5QM5QN5R5WTCType 1/Front RowType 2Type 3Type 4Type 4 WideType 5QMType 5QNType 5R (rectangular)Type 5W (round wide)Tennis C120-277V120V208V240V277V347V480VDark Bronze TexturedLight Gray XWhite TexturedCustom ColorCONTROL OPTIONSMOUNTING234567OAD Universal Arm for square poleAD5 Universal Arm for 5.5” -5.9” round pole90 shield left or rightAD6 Universal Arm for 6.0”-6.5” round pole270 shield front or back270 shield left or rightFull shieldCatalog NumberSWUSB*2.4”-4.1” Round Pole Adapter for AD armSWTAB*4.2”-5.3” Round Pole Adapter for AD arm5.5”-5.9” Round Pole Adapter for AD arm6.0”-6.5” Round Pole Adapter for AD armNot available with other wireless control or sensor optionsSpecify mounting height; 8 8’ or less, 40 9’ to 40’Specify routine setting code (example GENI-04). See ENERGENI brochure and instructions for setting table andoptions. Not available with sensor or SiteSync options.Specify group and zone at time of order. See www.hubbelllighting.com/sitesync for further details. Order at least oneSiteSync interface accessory SWUSB or SWTAB. Each option contains SiteSync License, GUI, and Bridge NodeOnly available with FR, 2, 3, 4, 4W and 5R distributionsOrder at least one SCP-REMOTE per project location to program and control the occupancy sensorThis product is approved by the Florida Fish and Wildlife Conservation Commission. Separate spec available specs/specs files/Viper Large LED turtle spec sheet.pdfPRECOMMISSIONED SITESYNC ORDERING INFORMATION: When ordering a fixture with the SiteSync lightingcontrol option, additional information will be required to complete the order. The SiteSync Commissioning Formor alternate schedule information must be completed. This form includes Project location, Group information, andOperating schedules. For more detailed information please visit www.hubbell-automation.com/products/sitesync/or contact Hubbell Lighting tech support at (800) 345-4928.SWBRGSW7PR RIGHT ROTATED OPTICDescriptionRemote Control for SCP/ F option. Order at least one perproject to program and control the occupancy sensorSiteSync interface software loaded on USB flash drive foruse with owner supplied PC (Windows based only). IncludesSiteSync license, software and USB radio bridge nodeWindows tablet and SiteSync interface software. Includestablet with preloaded software, SiteSync license and USBradio bridge node.SiteSync USB radio bridge node only. Order if a replacementis required or if an extra bridge node is requested.SiteSync 7 Pin on fixture module On/Off/Dim, DaylightSensor 120-480VAC* When ordering SiteSync at least one of these two interface options must be ordered per project. Available as a SiteSync retrofit solution for fixtures with an existing 7pin receptacle.Hubbell Control Solutions - Accessories (sold separately)Catalog NumberDescriptionHCS SystemNXOFM-1R1D-UNVOn-fixture Module (7-pin), On / Off / Dim,Daylight Sensor with HubbNET Radio andBluetooth Radio, 120-480VACNX DistributedIntelligence WIR-RME-LOn-fixture Module (7-pin or 5-pin), On / Off/ Dim, Daylight Sensor with wiSCAPE Radio,110-480VACwiSCAPE Lighting ControlSiteSync fixtures with Motion control (SWPM) require the mounting height of the fixture for selection of the lens.LEFT ROTATED OPTICdaylight controlGENI-XX3 ENERGENISWP1,4 SiteSync Pre-CommissionSWPM1,2,4 SiteSync Pre-Commission w/ SensorAccessories and Services (Ordered Separately)SCP-REMOTESiteSync onlySiteSync with Motion Control7PR-SC 7-Pin Receptacle w/Shorting Cap7PR-TL 7-Pin Receptacle w/Twist Lock photo controlSCP/ F1,2,6 Programmable Occupancy Sensor w/AD4 Universal Arm for 4.2” -5.3” round pole90 shield front or backExamples: /UNV/A/DB/SWPM-40F/control, or wireless control provided by others)or round poleMAF Mast Arm Fitter (formerly SF2) for 2-3/8”OD horizontal armK Knuckle (formerly PK2) limit to 30 tilt or2-3/8” OD horizontal arm or vertical tenonWB Wall BracketMOUNTING ACCESSORIES17PR 7-Pin Receptacle only (shorting cap, photoA Rectangular Arm (formerly RA) for square(Replace XXX with notation for desired finish color)(Refer to page 5 for shield 6BC Backsheid (available forFR, 2, 3, 4, 4W Optics)Platinum Silver SmoothAD3 Universal Arm for 2.4”-4.1” round poleHOUSE SIDE SHIELD ACCESSORIESOPTIONSF FusingBSP Bird SpikesBlack TexturedFor additional information related to these accessories please visit www.hubbellcontrolsolutions.com. Optionsprovided for use with integrated sensor, please view specification sheet ordering information table for details.SiteSync 7-Pin Module SiteSync features in a new form Available as an accessory for new construction or retrofitapplications (with existing 7-Pin receptacle) Does no interface with occupancy sensorsSW7PRBeacon Products 2041 58th Avenue Circle East Bradenton, FL 34203 Phone: 800-345-4928Due to our continued efforts to improve our products, product specifications are subject to change without notice. 2019 BEACON PRODUCTS, All Rights Reserved For more information visit our website: www.beaconproducts.com Printed in USA April 17, 2019 2:40 PM