Transcription
Fabric Pop-Up Display SystemFabric Pop-Up Set-Up Instructions 2018 Skyline ExhibitsTradeWinds is a registered trademark of Skyline Exhibits1PN 37834 C
Fabric Pop-Up Models8' STRAIGHT WITH END PANELS10' STRAIGHT WITH END PANELS8' CURVED WITH END PANELS10' CURVED WITH END PANELS 2018 Skyline ExhibitsTradeWinds is a registered trademark of Skyline Exhibits2PN 37834 C
Frame Set-Up1Lay the frame down so the leveling feet areon the floor and the fabric covered hubsare positioned away from you. Grab thetop frame rods near the middle, and lift upallowing the frame to expand.2Expand the frame up and out until the hubconnectors are almost touching.3Starting with the hubs nearest you, push thehubs toward one another joining the connectorsuntil they click, locking them together. Workyour way around the frame, fastening all theconnectors. Lean the top of the frame backtowards you to reach the top row. 2018 Skyline ExhibitsTradeWinds is a registered trademark of Skyline Exhibits3PN 37834 C
End PanelsTo attach end panels, standbehind the frame near onecorner then lean the frameback towards you to grab thetop unattached corner of oneend panel. Do not stretch fabricexcessively, but pull the endpanel back to match the hookand loop patch on the side ofthe top hub with the patch onthe end panel. Press firmlyto attach the hook and looppatches together.4Return the frame to its uprightstanding position and work yourway down the side of the endpanel to attach the remainder ofthe hook and loop patchestogether. Repeat the same stepsto attach the opposite endpanel.5To assemble lights, slide directlyon to top hub of frame. 2018 Skyline ExhibitsTradeWinds is a registered trademark of Skyline Exhibits4PN 37834 C
Frame DismantleDetach fabric end panelsbefore collapsing frame.Release the frameconnectors - leavingthe center connectorfor last. Make sureall the connectors arecompletely separatedbefore collapsing frame.Use caution as the aluminumrods can bend if forced. Allow theframe to partially collapse then tilt theframe towards you and lay the frameon the floor with the fabric up.With the frame on the floor, arrange thefabric so it is spread evenly across theframe. This will prevent the fabric frombunching up when the frame is fullycollapsed.Pick one corner of the frame up andwalk it over to the diagonal corner,fully collapsing the frame. With framefully collapsed, pack display into softsided wheeled bag or hard case forstorage and transport.Place frame in protective bag.Pack into wheeled bag or hard case. 2018 Skyline ExhibitsTradeWinds is a registered trademark of Skyline Exhibits5PN 37834 C
Graphic Cover ReplacementSet up the frame according to theinstructions.Lay frame on floor with the coverfacing up.Remove the cover by detachingthe hook and loop patches on thebackside of the cover from the looppatches on the frame hubs.Unfold the replacement covercompletely and position it over theframe.Starting at one of the top corners,attach the hook and loop patch onthe replacement cover to the looppatch on the frame. Continue to workalong the top edge attaching the restof the hook and loop patches, thenmove to one of the bottom cornersof the frame to connect the hookand loop patches along the bottomedge. Finish by connecting the sidesand ends of the cover to smooth thefabric. 2018 Skyline ExhibitsTradeWinds is a registered trademark of Skyline Exhibits6PN 37834 C
Fabric Pop-Up Display System Fabric Pop-Up Set-Up Instructions. 2 PN 3834C 2018 Syline Ehibits TradeWinds is a registered trademar of Syline Ehibits Fabric Pop-Up Models 10' STRAIGHT WITH END
