WIXLIB

PLEASEREAD AND SAVE THESENewAir AC-10000E, AC-10000HPortable Air ConditionerOwner'sManualINSTRUCTIONS

GENERAL SAFETY INSTRUCTIONS:ALWAYS OPERATE THE UNIT IN ANUPRIGHT POSITION AND PLACE IT ONA FLAT, LEVEL SURFACE AT LEAST 14"(36CM) AWAY FROM ANY OTHEROBJECTS (FIG 1 & 4).FIG. 1DO NOT PLACE OBJECTS ON THEUNITAND DO NOT COVER OROBSTRUCT THE INLET OR OUTLETGRILLES (FIG. 2).THIS APPLIANCEIS NOT INTENDEDFOR USE BY PERSONS (INCLUDINGCHILDREN) WITH REDUCED PHYSICAL,SENSORY OR MENTAL CAPABILITIES,OR LACK OF EXPERIENCE ANDKNOWLEDGE, UNLESS THEY HAVEBEEN GIVEN SUPERVISION ORINSTRUCTION CONCERNING ITS USEBYA PERSON RESPONSIBLE FORTHEIR SAFETY. CHILDREN SHOULD BESUPERVISED TO ENSURE THAT THEYDO NOT PLAY WITH THE APPLIANCE.ELECTRICALFIG. 2FIG. 3SAFETY: THIS APPLIANCEUSE ONLY.IS FOR INDOOR ALWAYS SWITCH OFF THE UNITANDUNPLUG IT WHEN NOT IN USE. DO NOT USE THIS UNIT INEXCESSIVELY HUMID OR WETENVIRONMENTS (FIG 3) DO NOT PULL OR PLACE STRAIN ONTHE POWER CORD WHEN MOVINGTHE APPLIANCE. IF THE POWER CORD IS DAMAGED,IT MUST BE REPLACED BYANELECTRICIAN OR SPECIALIZEDTECHNICIAN AUTHORIZED BY THEMANUFACTURER IN ORDER TOPREVENT FIRE.FIG. 4

FOR MAXIMUM EFFICENCY:Make sure doors and windows are closed while the portable air conditioner is in use.Also keep curtains and blinds closed during the sunniest parts of the day while it is inoperation.Frequently clean the filters.Once the room or area has reached your desired comfort level, be sure to reduce theunit's temperature and ventilation settings.

FrontBackFIG.61.2.3.4.5.6.Display windowControl panelControl buttonsLouversCarrying handleCasters7.8.9.10.11.12.Cord wrapAir filterAir inletExhaust air outletAir inletWater plug/drainage portAccessories13.Hose adaptor (goes over hose andinto the window kit)14.Exhaust hose15.Activated carbon filter16.Extendable window kit17.Hose for continuous drainage18.Remote controlFIG.7

Installingthe ExhaustHose!/!fJFIG.8.Open the windowand insert the window2.Close the windowuntil the windowsize of the windowkit into the open gap.kit is held securely.kit and secure it with screws.You may need to adjust theThis techniquemay also be usedfor sash windows.Fit the exhausthose into the exhaustair outlet located at the back of the airconditioner.4.Attachthe hose adapteronto the exhaust5.Attachthe hose adapterto the windowkit.hose.

Positioningthe ExhaustInsert the exhaustHosehose intothe back of the unit and tightenit into place.iAvoid kinks and bends in theexhausthose.These cancause expelledmoist air toaccumulate,resultingoverheatingFIG. 9inand unexpectedshut offs (See Fig 9 & 10).The exhaustextendedhose may befrom 12 inches (300mm) to 59 inches (1500 mm),but for maximumefficiency,iFIG. 10coolinguse the shortestlength possible.FIG. 11WARNING:The includedspeciallyexhaustdesignedspecificationshose isto fit theof this unit.Do notextend it with your own hose, asthis can cause the air conditionermalfunction.toFIG. 12

Installing1.the ActivatedRemoveCarbonFilterthe filter frame from theunit.2.Removethe activatedcarbon filterfrom its plastic bag.3.Insert the activatedcarbonfilterinto the back of the unit.Reattachthe filter frame onto theunit.FIG.13

ControlPanelFIG.141.2.ON/OFF (power) buttonTimer button10.Heating mode indicator light (only for3.Timer indicator light11.Fan mode indicator light4.Temperature increase button12.Cooling mode indicator light5.Compressor indicator light6.Full water tank indicator light13.14.Automatic mode indicator lightMode selection button7.Temperature decrease button15.Fan speed (ventilation) button8.Low ventilation indicator light9.High ventilation indicator light16.17.Display windowRemote control receiverAC-10000H)Turning the Unit On and Off1.Press the ON/OFF button.The unit will start automatically.If the ambient temperature is:Higher than 74 F, the unit will operate in cooling mode.Higher than 68 F but below or equal to 74 F, the unit will operate in fan mode.Equal to or below 68 F, the unit will operate in heating mode (heating mode is onlyavailable on model # AC-10000H).,,The indicator lights showing any functions will turn on. Please note that the display windowwill only show ambient room temperatures ranging from 32 F to 122 F.To turn the unit off, press the ON/OFF button again.Setting the Mode/Function1.2.Press the MODE button to select the desired mode (cooling, heating, fan or automatic).The selected mode's indicator light will turn on.

Settingthe Temperature1.Press the UP or DOWN button to change the set temperature.2.The display window will then indicate the set temperature. If no temperature is set, thedisplay will show the room's ambient temperature.3.Please note that the default cooling temperature of this portable air conditioner is 75 F.Settingthe Fan/VentilationSpeed,Press the SPEED button to select the desired fan speed (high or low). The appropriateindicator light (high or low) will turn on accordingly.,If the unit is in AUTO mode, the fan speed will be automatically set according to the ambienttemperature (the appropriate indicator light will turn on). Please note that when the unit isin AUTO mode, the speed setting cannot be changed.Setting,,the TimerPress the TIMER button to set the desired number of operating hours (from 1 to 12 hours).When the set time has been reached, the machine will automatically turn off.The displaywindow will show the number of hours being set as you press the TIMER button. If theTIMER is not set, the unit will work continuously.By pressing the TIMER button without selecting any other modes or settings, you can setthe number of hours to be delayed before the unit turns on. For example, if you press theTIMER to "2", the unit will automatically turn on after 2 hours.HeatingMode (only for modelno. AC-IOOOOH)When the air conditioner is in heating mode, ambient warm air is recycled and used to heat yourimmediate area.The exhaustcold air to be removed.pipe will still need to be fitted onto the unit in order for theWhen in heating mode, the machine can be set on HIGH or LOWspeed.All of the above functionsthe includedcan also be performedwithremote control.The remote controlrequires2 AAA batteriesto operate.FIG. 15

Regulatingthe Air Flow DirectionTo control the air flow direction, adjust the knobon the louvers.FIG. 16PLEASE1.NOTE:To prolongminutes.the life of the compressor, after turning off the unit, please wait at least 3before turning it back on.The coolingsystem will switch off if the ambienttemperature(the ventilationwill keep workingtemperaturerises above the selectedtemperatureis lower than the setat the set level). If the ambientlevel, cooling will resume.

During the cooling process, some water will be extracted from the air and stored within theunit's water reservoir.If the water reservoir is full, both the compressor(press any button to stop the beeping sound).and motor will stop and the unit will beepThe full water tank indicator light will alsostart flashing.To resume cooling, empty the reservoir by following these steps:,,,,,Turn off the air conditioner and unplug itfrom the wall socket. To prevent waterleakage, avoid moving the unit when full.Place a container (such as a small pan)underneath the drainage port.Remove the water plug from the drainageport and allow the water to drain out.When the container is almost full, replacethe water plug back into the drainage portand empty the water container.Water plugRepeat until the water reservoir iscompletely empty.YCap for thewater plugS,7.Turn the unit back on.should be off.For Continuous Drainage portReplace the water plug back into thedrainage port and make sure it is firmly inplace.FIG.17The warning signalDrainageRemove the water plug from the drainageFIG.18port and retain it for future use.Connect the drainage hose included withunit to the drainage port as shown.Connect the other end of the hose into aWater plugdrain.Cap for thewater plug10

eusinga suitableconnector.PLEASE,FIG.19Drainage hoseincluded with the unitNOTE:The drain must be at or below the levelof the drainage port.,FIG.20The full water tank indicator light will notwork when the unit is beingcontinuously drained.,Drainage hoseipcluded with the unitTo extend the drainage hose, you canconnect it with another hose with an///overall diameter of 0.7" (18 mm).,If room humidity levels are over 85%, it!will be necessary to continuously drainthe unit using the drainage hose.For HeatingExtension hose (OD: 0.7")Mode (only for model no. AC-10000H)While using the heating function, please note the following:1.In order to properly exhaust cool air, make sure the exhaust hose and window kit areproperly installed (refer to page 4 for instructions).2.Set up the air conditioner for continuous drainage using the drain tube (refer to page 10 &11 for instructions).The working range for the heating function is 32 F to 68 Rheating if used in temperatures outside this range11The unit may not provide optimal

Always unplug the air conditionerfrom the power supply before cleaning.To maximize the efficiency of the air conditioner,regularly clean the unit.Cleaningthe Housing Use a soft, damp cloth to wipe the body clean. Never use strong chemicals, gasoline, detergents, chemically-treatedcloths, or any othercleaning solutions to clean the air conditioner, as these can all potentially damage the unit'shousing.Cleaningthe Filters: Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt from the filtersand then rinse them thoroughly under running water (no warmer than 104 F). Thoroughly dry the filters before replacing them back into the unit.PLEAENOTE:Never operate the unit without the filters.End of SeasonStorageCompletely drain any condensed waterfrom the unit.Set the air conditioner on fan mode(ventilation only) for a few hours tothoroughly dry the inside of the unit.Clean or change the filter.POWERCORDUnplug and wrap the power cord aroundthe cord wrap as shown (fig. 21).Place the unit back in its original cartonand store it in a clean, dry area.FIG.2112

Theair conditionerdoesnotfunction. The unit does not produce adequatecooling.The unit is noisy.The compressordoes not work.Never try to repairvoid your warranty Isthe fullwatertankindicatorlightflashing?Isthe ambientroomtemperaturelowerthanthesettemperature? Is the unit placed in direct sunlight? If so, closeany curtains or move the unit to a more shadedarea. Are too many windows Are there too many people in the room? Are there additional Is the filter dusty or dirty? Is the air inlet or air outlet blocked? Is the ambient room temperatureset temperature? Is the machine positioned Is the unit positioned Is the compressor's overheat protection functionactivated?If so, wait for the temperature todrop and then turn on the unit again.and dismantleand endangerIsthe air conditionerpluggedin?Isthe poweroutletfunctioningcorrectly?the unit yourself.the user.13or doors open?heat sources in the room?lower than theunevenly?on an even, solid surface?Unauthorizedrepairscan

ModelNumber:Voltage/AC-10000E115V / 60HzFrequencyPower ConsumptionAC-10000H909W / 8.3Afor cooling"/Power Consumptionfor heating"NIL830W / 7.6A300 m3/hAir Volume (Maximum Speed)DehumidificationCapacity2.1 pints/hr (1 L/hr)Compressor TypeRotaryRefrigerant TypeR-410A2Number of Fan SpeedsTimer1 12 hoursExhaust Pipe DimensionsO4.72" X 59.06" (O120x1500 mm)Product Weight50.7 Ibs (23kg)Product Dimensions (W x D x H)12.2" x 13.8" x 28"(310 x 350 x 710 mm )ADDITIONAL.REMARKS:The data marked with '*' may vary for technical reasons; for more accurate data, please referto the rating label found on the back of the unit.["",Measuring condition for the above specifications:tCooling -DB 95 F (35 C), WB 82.94 F (28.3" C)Heating - DB 68 F (20C), WB 59 F (15C)Green* D.B. dry bulb temperature room temperature* W.B. wet bulb temperature relative humidity14Reset Button*'TestButtonLight

newair ac-10000e, ac-10000h portable air conditioner owner's manual. general safety instructions: always operate the unit in an upright position and place it on a flat, level surface at least 14" (36cm) away from any other objects (fig 1 & 4). do not place objects on the unitand do not cover or