Transcription
SeriesRN/RQPACKAGED ROOFTOP UNITS,AIR-SOURCE HEAT PUMPS, WATER-SOURCE /GEOTHERMAL HEAT PUMPS, & OUTDOORAIR HANDLING UNTSRQ SeriesFeatures: Air-cooled or water-cooled condenser, with unitcapacities from 2-140 tons Available as a chilled water or non-compressorizedDX air handling unit, from 800-49,100 cfm Air-source, water-source, and geothermalheat pump options R-410A scroll compressors - one, two, or fourcompressor systems Variable capacity and variable speed scrollcompressors for load matching cooling andimproved part load efficiency Electric, gas, steam, or hot water heating AMCA certified and labeled low leakageeconomizer dampers Direct drive backward curved plenum fans Power exhaust and power return options Factory installed AAONAIRE total and sensibleenergy recovery wheels Double wall rigid polyurethane foam panelconstruction with a minimum R-value of 13 Service access doors with full length stainlesssteel piano hinges and lockable handles Double sloped stainless steel drain pansRN SeriesApplication FlexibilityMinimzes Installation Time and Reduces CostMakeup Air ApplicationsUp to 100% Outside AirDehumidication andFiltration CapabilitiesLarge Tonnage Rooftopswith Small FootprintsFactory Installed or CustomerSpecific Controls Options
SeriesRN/RQRooftop/Air HandlersAAON RN and RQ Series rooftop unitscontinue to lead the packaged rooftopequipment industry in performance andserviceability. Double wall rigid polyurethanefoam insulated cabinet construction and directdrive backward curved plenum fans allow RNand RQ Series units to have quiet, energy efficientairflow with high static pressure capabilities.RN and RQ Series units also feature lockablehinged doors which provide service access toall sections of the unit.Superior Features Cabinet construction consists of rigid polyurethane foam panels with G90galvanized steel on both sides and a closed cell polyurethane foam interiorcore. The inner wall protects the insulation from moisture damage, preventsmicrobial growth, and is easy to clean.Two inch rigid polyurethane foam insulated panels have a thermal resistanceR-value of 13 or greater, which exceeds the R-value of a cabinet with fourinch thick fiberglass construction. They also make the cabinet more rigid andresistant to damage and provide increased sound dampening.Access doors with full length stainless steel piano hinges and quarter turn,lockable handles provide improved reliability over single point hinges andmake the unit easily serviceable.Corrosion resistant polyurethane paint exceeds a 2,500 hour salt spray test.AMCA Certified low leakage gear driven economizer dampers are standardon RN and RQ Series rooftop units. AAON low leakage dampers meet theCalifornia Title 24 damper air leakage requirement. Optional Economizer FaultDetection and Diagnostics is also available with the low leakage dampers tomeet the California Title 24 requirements.Compressors and unit controls are contained within a compartment isolatedfrom the air stream for ease of service and increased sound dampening.Direct drive backward curved plenum fans provide improved energyefficiency and reduced maintenance versus belt driven fans.Double sloped stainless steel drain pans eliminate standing water which cansupport microbial growth and stainless steel construction prevents corrosionthat could lead to water leaks and contaminants in the air stream.Run test report, wiring diagram, and Installation, Operation, andMaintenance manual with startup form provided in control accesscompartment of every unit.5 year non-prorated compressor warranty, 15 year nonprorated aluminizedsteel gas heat exchanger warranty, and 25 year non-prorated55-140 ton RN Series Packaged Rootop Unit
Feature FlexibilityPremier Options Variable capacity and variable speed R-410A scroll compressors for loadmatching cooling and improved part load efficiency.Air-source, water-source, and geothermal heat pump options for energyefficient heating.Factory installed total or sensible AAONAIRE energy recovery wheels.Humidity control options including: High Capacity Coils, Modulating HotGas Reheat Humidity Control, Return Air Bypass, and Mixed Air Bypass.Chilled water cooling coils allow unit to tie into new or existing chilledwater system.Hot water or steam heating coils allow unit to tie into new or existingboiler system.Polymer e-coated coils are available to extend the life of the coils andprotect them in corrosive environments.Power exhaust and power return fans with economizer for applicationflexibility.VFD controlled and ECM driven supply, exhaust, and return fans for preciseairflow control, building pressure control, and reduced power consumption.Modulating gas heat with stainless steel heat exchanger provides greaterfuel efficiency, longer heater life, and improved occupancy comfort.SCR (Silicon Controlled Rectifier) electric heat control for reduced powerconsumption, longer heater life, and improved occupant comfort.Multiple high efficiency air filtration options.Unit controls options including factory installed customer provided controls.VFD controlled or ECM driven condenser fans for energy savings andrefrigerant head pressure control.Thermal BreakCutaway of double wall rigid polyurethane foam insulatedcabinet panel increases thermal resistance, reduces air leakage,and attenuates radiated sound. Thermal break reduces heattransfer between interior and exterior metal cabinet walls.Standard AMCA Certified AAONLow Leakage DamperDehumidificationAAON offers many humidity control options. Highcapacity cooling coils are available which allow formore dehumidification versus standard cooling coils.Return air bypass and mixed air bypass are availableon RN Series units for single coil humidity control.Modulating hot has reheat humidity control isavailable to provide energy efficient dehumidification,even with low sensible heat loads, without thetemperature swings common with on/off reheatsystems.High Ambient OperationWith robust design and construction, AAON equipmentcan be rated and operate to over 125 F (52 C) ambient.R-13 Double Wall RigidPolyurethane Foam PanelConstructionAAON is setting a new standard for performancewith double wall construction using closed cellpolyurethane foam insulation. Not only does it haveseveral times the insulating R-value, it creates a farmore rigid and stronger assembly with less air leakagethan fiberglass insulated panels.AMCA Certified and LabeledLow Leakage DampersGear driven economizer eliminates the excessplay and bind that occurs with linkage typeeconomizers. Standard AMCA Certified andLabeled AAON Low Leakage Dampers meet theCalifornia Title 24 damper air leakage requirement.
Rooftop Units (6-140 tons)RNCabinet -CooledIEERRN-006RN-007RN-008AUp to 14.8Up to 14.0BUp to 16.8Up to 13.9CUp to 20.2Up to -018RN-020RN-025Up to 16.0RN-030VerticalRN-026RN-031RN-040RN-050DUp to 12.0Up to 13.8Up to 16.5RN-060RN-070RN-055RN-065RN-075RN-090RN-105EUp to 17.5Up to 12.1Up to NACHorizontalUp to 13.8Up to 12.7RNA-020RNA-025RNA-030Up to 16.0Nominal 05303101*Dimensions vary depending on options selected. All dimensions are in inches Design cfm may be 30-50% greater or less than nominal cfm.60138
Wide Range of Capacities6-30 ton RN Series Air-Cooled CondenserPackaged Rooftop UnitL2-10 ton RQ Series Air-CooledCondenser Rooftop UnitHLWDimpled heat exchanger provides energyefficient heat transfer and has no internalturbulator, which can corrode over time.Rooftop Units (2-10 -008RQ-010CabinetVerticalorHorizontalAir-Cooled SEER Air-Cooled EERUp to 20.7Up to 14.8Nominal cfm Width* Height* Dimensions vary depending on options selected. All dimensions are in inches Design cfm may be 30-50% greater or less than nominal cfm.82
Ease of ServiceMicrochannel condenser coilsEase of ServiceAAON equipment is designed from concept to completionwith minimum service time as a primary factor. Readilyaccessible compressors and control components allowtimely evaluation of service issues without delay. Colorcoded wiring diagrams allow fast connection identificationand analysis and thus a reduction in down time and cost.Individual components and wires are also labeled forquick circuit evaluation. The result of this AAON standardprocedure is low service cost and greater unit run time.Invisible footprint condenser designAir Handling Unit OptionAAON RN and RQ Series outdoor air handling unitsprovide a hydronic cooling and heating option. Gas,electric, steam, and hot water heating are available on anRN and RQ Series air handling units. Cabinet construction issimilar to the packaged rooftop units with easily accessiblecoil connections.All double wall constructionSlide out filter accessSlide out filter access2-10 ton RQ SeriesColor-coded wiring diagramContinuous bulb sealAll components labeledR-410A scroll compressor
26-70 ton RN Series UnitAll components labeledR-410A scroll compressorsMakeup Air CapabilityAAON RN and RQ Series units have makeup air capability andcan be specified with up to 100% outside air. AAONAIRE energyrecovery wheels are available on makeup air units to increase theunit’s energy efficiency. High capacity cooling coils are availableto handle the higher latent load of outside air. Modulating gasheat and SCR electric heat are available to provide energy efficientsupply air temperature heating. Modulating humidity control isavailable to provide dehumidification without over cooling whenthe outside air humidity is above setpoint. Variable capacity scrollcompressors are available to provide energy efficient supply airtemperature control.AHRI Certified High EfficiencyThe RN Series is available with an IEER rating up to 20.2, whilethe RQ Series is available with a SEER rating up to 20.7.20.7 SEER 3 ton RQ Series UnitColor-coded wiring and wiring diagram20.2 IEER 14 tonRN Series UnitDirect drive backward curved plenum supply fanHorizontal Configuration11, 13, & 16-30 ton RN Series HorizontalConfiguration Unit with Factory ProvidedFinal FiltrationHorizontal configuration is available for RQ Series units (2-10tons) and RN Series units (11, 13, 16-30 tons). This configurationprovides a solution for applications that require horizontal ductwork;it does not require special horizontal supply/return curbs. All of thepremier features and options currently available for the RQ and RNunits are available with this configuration. High efficiency finalfiltration configuration is available on the RN Series unitsfor health care and other applications that require it.
High Efficiency OptionsElectric Preheat is available with all AAON energy recoveryoptions for frost prevention.Air-Source Heat Pump OptionEnergy efficient cooling and heating can be achieved by reversing theunit’s refrigeration circuits. This allows the indoor coil to be used as either acooling coil or heating coil. This is a more efficient method of heating thanelectric heating because a heat pump can reject more heat to the spaceper the amount of energy used. Thus, the operating costs of heat pumpheating are always less than the operating costs of electric heating. Heatpump heating can also a more efficient method of heating than gas heatingand, depending on the cost of electricity and natural gas or propane, heatpump heating can have less operating costs than gas heating.Compressor Capacity ControlRN and RQ Series units have a variety of compressor options availablefor load matching cooling, providing both high full load and part loadefficiency. Options include staged, two-step, 10-100% variable capacity,and variable speed compressors. Two-stage compressors provide a costeffective additional cooling capacity stage that improves part loadefficiency. Units with 10-100% variable capacity scroll compressors aresimple to control and the compressors have a wide range of capacitymodulation. Variable speed compressors use compressor motor speedcontrol to reduce capacity, save energy, and reduce sound.VFD controlled variable speed scroll compressorsprovide load matching cooling and improve partload efficiency.Variable compressors allow for a wide rangeof capacity control (10-100%) for improvedpart load efficiency with simple controls.Two-Step Scroll Compressors provide the simplicity of stagedcapacity control with high part load efficiencyTwo-Step Compressorsimprove part load efficiency withsimple staged control. Unit IEER can be optimized without requiring complexrefrigeration and DDC controls, reducing operating costs and maintenance costs.Two-step compressors are available in the RQ Series and 14 ton RN Series.
Variable Speed CompressorsVariable speed compressors provide load matching cooling and thehighest efficiency ratings when operating at part load conditions.Refrigeration controls are built-in to the AAON equipment to protectthe compressors and optimize the efficiency for VAV, Single Zone VAVand Makeup Air applications. Variable speed compressors are quiet inoperation, especially at reduced capacity.2-10 ton RQ Series with inverter driven variable speed compressors forload matching cooling and improved part load efficiencyWater-Source/GeothermalHeat Pump OptionEnergy efficient cooling and heating can be achieved byreversing the flow of the unit’s refrigeration circuits. This allowsthe indoor coil to be used as either a cooling coil or heating coil.Geothermal heat pumps take advantage of the relatively constanttemperature of the earth below ground level to transferheat to or from
Run test report, wiring diagram, and Installation, Operation, and Maintenance manual with startup form provided in control access compartment of every unit. 5 year non-prorated compressor warranty, 15 year nonprorated aluminized steel gas heat exchanger warranty, and 25 year non-prorated 55-140 ton RN Series Packaged Rootop Unit. Premier Options Variable capacity and variable speed .
